Tuesday, August 18, 2009

Let's start framing




Okay, so I started framing. Basically there's a few things to do. The shower is the most important so that I can finish up the plumbing. After that there is a half-wall to hide the toilet and and the platform for the tub. Oh and I have to frame a decent window and then frame a door. There wasn't a door into the bathroom before.






The shower is going to be a steam shower. Besides buying a steam engine, and running the dedicated electrical line and plumbing for that, I found out that this also means a few other things. First off, no natural stone. Water vapor will make it through into the walls and do bad things. Second, there seems to be a debate about whether to slope the ceiling. This is very important. With a flat ceiling, condensation will collect rapidly and drip furiously down upon you as you're trying to relax. Lastly, the entire shower (walls and ceiling) must have a vapor barrier.


I been measuring out my shower for weeks and think it has the right dimentions. Not too small or too large. So, the framing began. Two indespensible tools in this category. First, the miter saw. I love it. it's so amazing. Second is the nail gun I purchased for the construction of the closet. I can't tell you how fast the work goes. Now all I have to do is make is square, which I more or less did. I'm telling you, it's not as easy as it should be. I measured, marked, had my speed square handy and it was still a bit off.

Another note on framing a shower. Use 2x6's on the wet wall. You can squeeze it all in using 2x4's but if you can avoid that headache, do so.
Next I tackled the door. Here you get to deal with terms like king studs and jack studs. Basically this is pretty straight forward. Squareness is again important. I'm getting better at it.
Framing the window was pretty scary. That involves poking a hole into a perfectly good wall. You know, one that leads to the outside where snow and wolves are. My window was sitting in the garage so I felt pretty solid about how big I had to make this. I tried to be careful so that I would not destroy the outside panneling. It didn't work out and they don't make the exact kind of panneling anymore..of course. So, I'm hoping that gobs and gobs of paint will hide that fact.
The tub. Yeah, this was hard. Everything must be level, square and perfectly plumb. I had exact dimentions for the tub as provided by Jason tubs. The deck, was created out of 3/4 plywood using my jig saw. I have a crappy little saw. This took a while.
So the above took a few days all told. I'm wrapping it up here for reader convenience. I sure wish I had a jaccuzzi to relax in.

No comments:

Post a Comment