I haven't blogged for a while. Mostly because I've just been staring at the "Disaster Zone" and wondering how much it would cost to have someone finish. But then Jen made me some chocolate chip cookies and now I'm back on top.
The internet provides a log of good information on how to do stuff and the comment boards out there help too. So I was surprised to find how little information there is on building a steam shower, and in particular, building a shower pan. It mostly comes down to liners and stuff but you'd think someone would capitalize on this gap.
I'll skip a few steps here, but it starts with the pan. I had to make sure much earlier in the project that the floor could support the tub, 60 gallons and two people, along with a cement shower pan. Basically there are a few layers here. I used concrete grout made by Quickcrete. This stuff is designed to repair bridges and is much easier to work with than cement. I poured a base which is just designed to slope in toward the drain and support the pan. There was no guidance at all from anyone on the building the curb (where the door to the shower will be). I framed it out with 2x4's but what to do to make it part of the shower pan was not clear. Since I'm pouring mortar, I just decided to make it a wall of mortar. I made a mold, poured the mortar and had a pretty little wall which would be where the door was. Not sure how the pro's do this.
Once that hardened, I could put the liner down. This is basically a very thick plastic that HD sells for this purpose. It's very hard to fold in the corners. At this time I put in the thiner vapor barrier (Plasic sheet) around the whole shower. If you ever do this, get someone who is good at gift wrapping. You're basically wrapping a box with a single sheet of plastic, while standing in the box. The fewer cuts I had to make the less of an opportunity there'd be for water to get through.
Once done, I could then work on the drain and put all that down (skipping ahead quite a bit here). Then I mixed up a lot more quickcrete and basically poured and formed my shower pan.
There's a pretty accurate description of the process with pictures here. http://www.ontariotile.com/preslope.html This looked pretty much like mine.
The fear facor came in when I realized that if I had made a mistake of some kind, I now had 100 pounds of hard mortar in my bathroom. Anyway, at the end of the day today I had a liner in there and a new shower pan. As long as water goes down the drain and not down through the floor, I'm going to be happy.
No comments:
Post a Comment